Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ST10 Part Family Table

Status
Not open for further replies.

blitz97

Mechanical
Joined
Apr 25, 2007
Messages
79
Location
US
Whenever we create a family of parts and add a table with the associated variables to a drawing, they are always listed as 3 place decimal tolerance. We cant determine how to change the tolerances of the variables listed in the table.

Has anyone had any dealings with this?
 
I figured it out.

for St10, just in case anyone needs to know, the "Base unit" tolerance for the "Length" measurement under the Units section for the drawing itself needs to be set at the tolerance you want. This can be found under the Solid Edge options.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top