Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Digester foaming 1

Status
Not open for further replies.

JohnWeal

Mechanical
Joined
Dec 16, 2012
Messages
124
Location
GB
Good Afternoon,

The client specifications require the biogas offtake to be a minimum of 1.5m above the sludge liquor level.

Has anyone on this forum experienced foam entering the offtake pipeline and if so, what are the consequences and remedial actions required?

The offtake pipework is DN200 with a maximum gas yield of 370 m3/h

Regards
John
 
On the last digester project, the gas outlet was in the center well of the gas holder, as high as possible. If the foam gets into the gas outlet, you may have a mess to clean up as the foam will be caught in the Condensate and Sediment Trap with drip trap. Foam out of the digester may clog gas handling equipment. A separate foam separator is also available to remove the foam.

We also installed a radar level instrument to measure the foam, a liquid level instrument to measure liquid level, a 3rd gauge to measure the level of the digester cover, gas flow meters, and viewing ports.

The following article describes the problems:

Foaming

Link 2

Link 3
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top