TRIAXIAL TESTING - SIGMA CU PROGRAM
TRIAXIAL TESTING - SIGMA CU PROGRAM
(OP)
Dear all,
Please I am having some problems with the program Sigma CU from GEOTAC since this was reinstalled again in the computer.
We have entered the calibration values but it still shows error messages.
In the error file says: Error reading External Load Cell
And when i open the program it takes too much time opening, like it want to corrupt, but also it shows up a message: Encountered error while setting address of module 1.
I am really urgent to solve this problem, because I have samples to test.
Please i appreciate your help with it.
Best regards,
Cristina
Please I am having some problems with the program Sigma CU from GEOTAC since this was reinstalled again in the computer.
We have entered the calibration values but it still shows error messages.
In the error file says: Error reading External Load Cell
And when i open the program it takes too much time opening, like it want to corrupt, but also it shows up a message: Encountered error while setting address of module 1.
I am really urgent to solve this problem, because I have samples to test.
Please i appreciate your help with it.
Best regards,
Cristina
RE: TRIAXIAL TESTING - SIGMA CU PROGRAM
I'm also not sure this belongs in the Slope Stability sub-forum - better in the Soil Testing one.
RE: TRIAXIAL TESTING - SIGMA CU PROGRAM
I will move this to the other one, and also call to GEOTAC.
Best regards,
Cristina