Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Think and Do software Learning

Status
Not open for further replies.

elfman

Mechanical
Joined
Oct 21, 2003
Messages
79
Location
US
I recently started a new position with a new employer - large factory - complicated product. We have an old-time automation engineer that is a 'Think and Do' only kind of guy (We also have a lot of Labview being done here). I would like to learn Think and Do so I can help him bring some of his code - and the usability thereof - up to modern times. Phoenix Contact only offers Think and Do training courses twice a year and I would like to start learning it sooner - do you have any recommendations for learning the software and taping its fullest capabilities? Thank you in advance!

"To be or not to be, that is the question" - William Shakespeare via Hamlet
 
Sadly the websites that are listed above only document where to purchase the software - I have not been able to find anything on AutomationDirect.com's website that has anything that would remotely be termed tutorials or learning forums. I beginning to believe that Think n Do is a dying product and there just isn't much out there.

"To be or not to be, that is the question" - William Shakespeare via Hamlet
 
Look over youtube and see if there are videos there on tutorial on think and do from automation direct.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top