Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Response Speed of 'End Point' etc.

Status
Not open for further replies.

aduetto

Mechanical
Joined
Dec 29, 2002
Messages
21
Location
US
I'm an occasional user of DS and have wonder if my issue is a common one. When I'm drawing a line, or other tool, it seems like I have to wait in the vicinity of an 'end point', 'midpoint', etc. label to show. Or at least to wave my pointer around a bit. Plus they don't always show up. My computer isn't the fastest dog around, but it's not the slowest either (see attachment). Any thoughts?

I usually have either Polar or Ortho on, esmap on, and sometimes etrack. Sometimes these seem to work against each other, but I guess I figure that as I get experience using them.
 
 http://files.engineering.com/getfile.aspx?folder=69174443-f028-42c2-8ffb-afe53f38e88a&file=cpu-z.gif
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top