Pop hinge assistance
Pop hinge assistance
(OP)
I am working on a non-living hinge between two plastic parts.
The hinge will get loaded in two directions perpendicular to the rotation axis and perpendicular to each other.
It should hold quite some force (ideally 100N) but still be able to "fail" gracefully so the parts can be reassembled...
Therefore i am looking at a pop hinge.
However i have not been able to find any design guides for pop hinges.
Am I on the wrong track or do you guys have any ideas or resources on this?
Thanks for reading
Best regards
Morten
RE: Pop hinge assistance
Cheers
H
www.tynevalleyplastics.co.uk
Politicians like to panic, they need activity. It is their substitute for achievement.