Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Radial flange face damage

Status
Not open for further replies.

Kenneth Kozoway

Mechanical
Joined
Aug 24, 2016
Messages
1
Location
CA
What is the acceptable radial acceptance criteria for face gouges
 
What's the flange standard you're concerned about? I believe that ASME PCC-1 has advice.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top