ACAD LT 2016
ACAD LT 2016
(OP)
I'm wondering if my ACAD LT 2016 is corrupt.
In general, i will concede to user error - there is typically something i simply do not understand.
When i draw a line, i can start the line from 0,0, BUT, for some reason, when i attempt to draw a line, i will click at a random point in (the black) space, but, when i want the second point to be 0,0, when i type "0,0" ACAD does not recognize this.
I'm fairly new to ACAD LT 2016, therefore, i suppose i am simply not understanding something.
What am i doing wrong?
Thank you!
In general, i will concede to user error - there is typically something i simply do not understand.
When i draw a line, i can start the line from 0,0, BUT, for some reason, when i attempt to draw a line, i will click at a random point in (the black) space, but, when i want the second point to be 0,0, when i type "0,0" ACAD does not recognize this.
I'm fairly new to ACAD LT 2016, therefore, i suppose i am simply not understanding something.
What am i doing wrong?
Thank you!
RE: ACAD LT 2016
http://www.cadforum.cz/cadforum_en/qaID.asp?tip=58...
Vladimir Michl
RE: ACAD LT 2016
Between your comments and the cadforum, i solved the problem.
I've been using ACAD for twenty years and have not experienced this necessity of the extra key-strokes.
I'm noticing with my updated version of ACAD LT 2016, that i'm having to enter more key-strokes than in the past, to accomplish the same basic commands. I thought less keystrokes was the efficient method.
RE: ACAD LT 2016
RE: ACAD LT 2016
As stated in the “Display Coordinate” thread, I conclude that my settings were altered during a tech support "enhancement" or modification to our network. Nothing intentional, just unfortunate and frustrating.
I simply need to gradually, as time permits, do the necessary research to get my settings back to where I desire them. This will inevitably result in future inquiries to this particular forum.
Thank you again!
RE: ACAD LT 2016
Did they leave your old version installed? One thing I always did was to leave the old one installed for a month or so before removing it - this way, I had a chance to identify settings/issues in the new version, and either export a new partialCUI file from the old software, or just double-check sysvars and settings. It served as a go-by.