Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

RCC-M : RMC 2410

Status
Not open for further replies.

R4FKEN

Nuclear
Joined
Mar 15, 2016
Messages
14
Location
BE
RMC 2410 states that only straight probes are allowed for UT of thicknesses over 60 mm. A colleague of mine is convinced that this implicates the plates have to be scanned from both surfaces, because of the dead zone of straight probes. It's impossible for me to change his mind: i believe this dead zone has been considered during writing of RMC 2410 and, as a result, scanning from one side is sufficient. Anyone with experience with this paragraph?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top