Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to draw a Wave Spring Washer in Geomagic Design

Status
Not open for further replies.

RowlyC

Industrial
Joined
May 24, 2015
Messages
1
Location
GB
Hi All, I am new here.
I just need a bit of advice on How to draw a Wave Spring Washer in Geomagic Design.
I have found Youtube Vid, on how to do it in Solidworks.
But i Cant achieve it yet, in Goemagic Design.
I just wondered, if was Possible in Geo, using similar technique, or am I wasting my time.
Any tips would be appreciated.
I need to be able to edit, No of waves, wave depth, Diameters & Thickness
Thanks
Rowland C
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top