Question : How to create a point
Question : How to create a point
(OP)
Hi everybody,
I would like to ask a question about Geomagic qualify .
I want to create a point on a model . it is a ply file ( polygon ) .This model is a 3D recording. I would like define the x and y coordinates by myself. The z coordinate should be defined by the Programm so that the Point is in contact with surface of my model.
How can I achieve this .
Thank you in advance .
Tolga
I would like to ask a question about Geomagic qualify .
I want to create a point on a model . it is a ply file ( polygon ) .This model is a 3D recording. I would like define the x and y coordinates by myself. The z coordinate should be defined by the Programm so that the Point is in contact with surface of my model.
How can I achieve this .
Thank you in advance .
Tolga
Talk To Other Members
RE: Question : How to create a point
Here is a link to the instruction manual for Geomagic Qualify . I cannot do any better than this because this is a forum for Geomagic Design.
B.E.
You are judged not by what you know, but by what you can do.