Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Weld Deposition rate in AWS D1.1 & D1.8?

Status
Not open for further replies.

AhmedDawn

Mechanical
Joined
Mar 25, 2015
Messages
2
Location
SA
Hello Gents,

I am newer to Welding. I was going through AWS D1.1 & D1.8 to check the values and ranges for:
1. "Weld Deposition Rate" for SMAW & FCAW.
2. Weld Single pass thickness for SMAW & FCAW processes

As-usually I checked it in several clauses but due to lack of knowledge to AWS codes I am unable to find it. Is there any body to help out me to solve these tiny mysteries.

Cheers

A. Ahmed

 
not sure about d1.8. But for d1.1 single pass thickness maximums are in table 3.7. Deposition rates aren't limited under d1.1. I would think that's because deposition volume is a function of amperage and technique. It would be difficult to quantify maximums or minimums.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top