Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Manufacturing standards for Cross Recessed Undercut Screws 2

Status
Not open for further replies.

hinged

Mechanical
Joined
Jun 6, 2002
Messages
22
Location
US
I'm looking for more information than supplied in the IFI Standards book for manufacturing tolerances and dimensions for cross recessed( #3 phillips) undercut flat countersunk head tapping screws. PLease direct me to other sources if available.
Thank you
hinged
 
Try ISO 7046-1 and the other standards to which it refers.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top