Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pressure vessels alignment tolerances

Status
Not open for further replies.
StudB8

StudB8

Mechanical
Joined
Dec 14, 2013
Messages
8
Location
SA
anybody please advice about reference standard for pressure vessels alignment tolerances ..

in most projects i find such tolerances in project specification (1mm/meter length of the vessel with maximum 25mm), but actually i dont
know such tolerances based on which standard..
note: the pressure vessel built according to ASME VIII and will be installed in refinery project in middle east.

anybody help is totally appreciated.

 
Status
Not open for further replies.

Similar threads

142846
  • Locked
  • Question Question
wellhead Shut-in pressure
Replies
8
Views
1K
SJones
SJones
Tuga29
  • Locked
  • Question Question
Pipeline Pressure Restfill
Replies
11
Views
479
1503-44
1503-44
JeremyOG1990
  • Locked
  • Question Question
Pump pressure
Replies
11
Views
568
LittleInch
LittleInch
bcavender
  • Locked
  • Question Question
Pressure gradient in a low pressure, low flow, dry, natural gas well
Replies
10
Views
768
1503-44
1503-44
TzPetro
  • Locked
  • Question Question
Hydrostatic Pressure Testing
Replies
2
Views
276
LittleInch
LittleInch

Part and Inventory Search

Sponsor

Back
Top