Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

B18.3 length tolerence of fully threaded SHCS

Status
Not open for further replies.

kvj

Mechanical
Joined
Jul 30, 2003
Messages
2
Location
US
We do not have a copy of B18.3 and not in the budget to purchase one. We really have had no other need for the spec but for this rare case. If this request is not acceptable on this forum, my apologies.
Machinery's Handbook (21st Edition, pg. 1202) doesn’t address manufacturer tolerences. I am looking for the length tolerence of dim “L” on that specific page.
I did pose my question to our vendor but they could only steer me to B18.3.
My question, what is the length tolerance for the fully threaded portion of a socket head cap screw. Specifically, for ¼-20 x .75 long and 1 long. I imagine the tolerences will be the same for those lengths.

Thanks,
KJV
 
Length (L) tolerance is listed as -.03 on lengths upto 1.00 inch and 0 thru 3/4 diameter.
Taken from ASME B18.3-2003


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top