Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Materials to make a mold for processing prepregs 1
- Thread starter suganth03
- Start date
MikeHalloran
Mechanical
It also has to deal with release of water as the phenolic cures, so maybe a one-side mold with a vacuum bag, peel ply, etc. would work better than matched dies.
I think you could use a wooden mold at 180C, depending on how many re-uses you need to get out of it.
Mike Halloran
Pembroke Pines, FL, USA
I think you could use a wooden mold at 180C, depending on how many re-uses you need to get out of it.
Mike Halloran
Pembroke Pines, FL, USA
-
1
- #3
- Status
Similar threads
- Question
- Locked
- Question