Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

B1.16M Screw Threads

Status
Not open for further replies.

QAFitz

Materials
Joined
Jul 21, 2005
Messages
121
I believe Table 10 of the 1984 version has a typo for the Internal Thread Pitch Diameter for a M20x2.5 (page 45 of the ANSI Standard). Before I purchase the new Standard, can anybody tell me if this has been corrected? The 1984 Table entry is 16.376 / 16.384, and these should be 18.376 and 18.384 (or correct me if I'm wrong).
Again, before I purchase the new Standard, can anybody tell me if this has been corrected?
Thanks in advance for your time.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top