Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Blade pole-piece bobbins

Status
Not open for further replies.

Ludus

Civil/Environmental
Joined
Apr 13, 2010
Messages
1
Location
BA
I made and re-wind some of single-coil pickups for my Strat. they were damaged by sweat and some of them were poor manufactured. As results of my job was good I wished to start making some humbuckers but with bobbins that have blade (rail) pole-piece, single or double, just most important is that bobbins dimension match size of classic HB bobbins. I tried at StewMac and many other places but without success. Laso, I need also some place where is possible to obtain Alnico 2, 5 and ceramic magnets suitable for HB. Any info I'll appreciate. Thank you.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top