Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Fanuc RJ---Would like to recieve data from VISION SYS??

Status
Not open for further replies.

SIDESTECH

Electrical
Joined
Jan 13, 2010
Messages
2
Location
US
OK.... What I have is a 420-FD with a RJ controler. I went through the re registration process for this robot.(very expensive) Anyhow, I'm trying to integrate a Banner presence pro plus system. So, I'm going from the vision board to a PC by ethernet and would like to send the results to the robot with the P3 seriel port on the front of the controler. I tried to get support from Fanuc on this but have had absolutly no help. Anyone here done this before?
 
Yes thats the issue. I'll give that a try thanks for the tip....
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top