I am looking into hydrogen embrittlement testing for some cadmium plated carbon steel Spring Pins and I'm not too sure about some of it. I understand you have to install them in holes or rods of a certain size but are there any other requirements for these holes(such as depth)?
Red Flag Submitted
Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Eng-Tips forums is a member-only feature.
Material selection can be a guessing game, but it doesn’t have to be. If you’re an engineer looking to quantitatively analyze a material to determine if its properties fit your application, then you’ll need to be ready with a wide range of facts. Download Now
Teach pendants are a critical part of the factory environment as they act as the human/machine interface for industrial robots. But since teach pendants are handheld, they are under a greater risk of damage due to falls. Download Now
Product development in most companies requires a sequential iterative process to come up with the right product. It can be time-consuming and time is a resource that is in the shortest supply. Download Now