Hi!
We have a centrifugal blower designed for 7000 lpm at an operating pr. of 100 psi(g). Working fluid is SF6 gas. We tested our system for air at the working pr. of 100 psi(g). But we do'nt get the required flow of 7000 LPM ,but less than half the design value. Probably the Head loss is more. What could be the remedy, without making big changes in the piping
"Knowledge is power"
We have a centrifugal blower designed for 7000 lpm at an operating pr. of 100 psi(g). Working fluid is SF6 gas. We tested our system for air at the working pr. of 100 psi(g). But we do'nt get the required flow of 7000 LPM ,but less than half the design value. Probably the Head loss is more. What could be the remedy, without making big changes in the piping
"Knowledge is power"
