Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Intersection point detection in FTA

Status
Not open for further replies.

ocad

Mechanical
Joined
Oct 2, 2007
Messages
9
Location
SE
Hallo!
I have a question about the Functional Tolerancing & Annotations module (FTA). In the Drafting module it is possible to use the commando Intersection point detection. I have tried to find that commando in the FTA-module but have not succeeded. I wonder if someone knows if possible to find an Intersection point in the FTA-module?

Thanks to all answers and suggestions.

/Ocad

 
If you are trying to dimension from one plane/surface to the intersection of two other planes/Surfaces that are not parrallel to the first, you can use the "Construction Geometry Creation" tool to create an axis at their intersection. Then create the dimension from the plane/surface to the axis.

If this is not the case, could you explain in more detail.
 
Thanks Runz! It was exactly this commando I were looking for.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top