Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

re: Circuit Board Torque

Status
Not open for further replies.
Nate360

Nate360

Mechanical
Joined
Dec 13, 2001
Messages
7
Location
US
Can anyone assist with a PCBA torque inquiry?

A #10 pan head screw (.190 head OD) is being used to mount a clip. The board is 0.063" thick.
I would like to know the point at which the board begins to cold flow (under what force).
I am trying to set the proper torque for mounting this clip.
 
Status
Not open for further replies.

Similar threads

Navid.Nik
  • Locked
  • Question Question
Checking bolt torque in freezing condition
Replies
5
Views
611
CWB1
CWB1
struclearner
  • Locked
  • Question Question
Torque of Bolt with Spacer in a Bolted Joint
Replies
6
Views
1K
FacEngrPE
FacEngrPE
BrysonRD
  • Locked
  • Question Question
Welding and Re-machining Cast Iron
Replies
17
Views
2K
Tmoose
Tmoose
JoshRanch
  • Question Question
AWS 5.01 Requirements for reviewing Filler Metal Supplier Quality Program
Replies
1
Views
377
David3399
D
EngTal
  • Question Question
Overtightening a bolt beyond its recommended bolt load.
Replies
11
Views
7K
dcascap
dcascap

Part and Inventory Search

Sponsor

Back
Top