Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
MS 5479, PS 6151a and PS 7099 1
- Thread starter rivtim
- Start date
-
1
- #2
All three are DaimlerChrysler Engineering Standards. MS-5479 specifies the requirements for carburized high-strength serrated studs. PS-6151 specified the identification requirements for metric fasteners, and PS-7099 is a general fastener specification. MS-5479 also references a number of other standards such as DCX PF-5188 and SAE J1102. DaimlerChrysler Engineering standards can be obtained directly from DCX via Covisint.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question