Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

weld tolerances

Status
Not open for further replies.
markqcmgr

markqcmgr

Mechanical
Joined
Jul 7, 2006
Messages
1
Location
US
We have some fabrication prints that state a tolerance of
+ or - .015'', is this the standard for welding?
 
Sort by date Sort by votes
That sound mighty tight for structural steel fabrication, but it may be reasonable if you are working on very small electronic components.

Best regards - Al
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

duongwe
  • Locked
  • Question Question
welding consumable select and preheat for JIS G4051 S45C weld to ASTM A572 Gr.50
Replies
0
Views
307
duongwe
duongwe
MCQE
  • Locked
  • Question Question
Quality Check on PED weld seamer
Replies
2
Views
304
r6155
r6155
A
  • Locked
  • Question Question
Welder Qualification
Replies
2
Views
4K
pipewelder1999
pipewelder1999
Alessandro Lavista
  • Locked
  • Question Question
Visual Inspection tooling for titanium weld discoloraution
Replies
2
Views
614
Alessandro Lavista
Alessandro Lavista
65CCJ
  • Locked
  • Question Question
MONEL BODY X MONEL DISK X MONEL BODY - DIFFICULT TO GET GOOD WELD PENETRATION DEPTH
Replies
4
Views
430
Dhurjati Sen
Dhurjati Sen

Part and Inventory Search

Sponsor

Back
Top