Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Book Review?

Status
Not open for further replies.
hbarea

hbarea

Mechanical
Joined
Nov 21, 2002
Messages
41
Location
US
Has any one read the book “Computer Aided Design with Unigraphics NX3: Engineering Design in Computer Integrated Design and Manufacturing” by H Felix Lee and David Fulton (ISBN: 0-7575-2196-7)?

If you have read it, what is your opinion?

Can you compare it to "Practical Unigraphics NX3 Modeling, Drafting and Assemblies" by Stephen Samuel, Anuranjini Pragada and Gautam Baksi (ISBN 097543772)?
 
Status
Not open for further replies.

Similar threads

Dikuza
  • Locked
  • Question Question
NX: How to ignore touching pairs in Clearance Analysis and only review for hard interferences?
Replies
2
Views
704
cowski
cowski
moog3
  • Locked
  • Question Question
start with bookmarks
Replies
2
Views
246
moog3
moog3
TheWonderer
  • Locked
  • Question Question
Looking for NX10 training book
Replies
3
Views
161
looslib
looslib
munners
  • Locked
  • Question Question
Xpress review Manual
Replies
0
Views
110
munners
munners
sebaz
  • Locked
  • Question Question
Nx Surface Modeling/general Books?
Replies
2
Views
208
joycejo
joycejo

Part and Inventory Search

Sponsor

Back
Top