Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

1port calibration - TRL?

Status
Not open for further replies.
88888888

88888888

Electrical
Joined
Oct 2, 2001
Messages
7
Location
GB
I have TRL standards (2-port calibration) on my wafer but my DUT is a 1-port device. How do I overcome the calibration problem?
 
Sort by date Sort by votes
I'm sure you have an answer by now, but anyway...
You really have no problem. Perform your two-port TRL cal and then measure your one-port device (S11). Everything will be fine and calibrated, it will just take twice as long because the network analyzer needs to measure all four S-parameters to calculate the two-port error correction.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

calConfusion
  • Locked
  • Question Question
Network analyser calibration
Replies
4
Views
263
biff44
biff44
logbook
  • Locked
  • Question Question
Waveguide offset pieces (spacers) for calibration
Replies
2
Views
207
logbook
logbook
RFTroubleshooter
  • Locked
  • Question Question
Is TRL calibration with 8753C VNA possible?
Replies
2
Views
200
RFTroubleshooter
RFTroubleshooter

Part and Inventory Search

Sponsor

Back
Top