Dec 17, 2004 #1 kadego Automotive Joined Aug 24, 2004 Messages 59 Location AU Hi I have just updated a sketch which is extruded. When I try to make a feature further down the tree current I get an error message 'A deleted or invalid class id was used'. Anyone know what this means? Dave
Hi I have just updated a sketch which is extruded. When I try to make a feature further down the tree current I get an error message 'A deleted or invalid class id was used'. Anyone know what this means? Dave
Dec 17, 2004 #2 Xwheelguy Automotive Joined Mar 17, 2004 Messages 2,048 Location US Can you make any other features current BEFORE the one that is giving you the error? Personally, I would step through each feature one by one until I got the error, then call GTAC & have them look at the problem. Tim Flater Senior Designer Enkei America, Inc. http://www.enkei.com Upvote 0 Downvote
Can you make any other features current BEFORE the one that is giving you the error? Personally, I would step through each feature one by one until I got the error, then call GTAC & have them look at the problem. Tim Flater Senior Designer Enkei America, Inc. http://www.enkei.com
Dec 17, 2004 #3 cowski Mechanical Joined Apr 23, 2000 Messages 8,227 Location US Sometimes those type of errors go away when you restart UG and reopen the part (emphasis on sometimes). Upvote 0 Downvote
Sometimes those type of errors go away when you restart UG and reopen the part (emphasis on sometimes).
Dec 17, 2004 Thread starter #4 kadego Automotive Joined Aug 24, 2004 Messages 59 Location AU nk Yes I could pick features before. It was the extrusion that was giving me grief. I reopened the part and did exactly the same thing again. This time no problem. Just one of lifes little mysteries I guess. Dave Upvote 0 Downvote
nk Yes I could pick features before. It was the extrusion that was giving me grief. I reopened the part and did exactly the same thing again. This time no problem. Just one of lifes little mysteries I guess. Dave