Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations 3DDave on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

XYZ coordinates table

Thread starter wben
Start date Nov 22, 2016

Status: Not open for further replies.

Nov 22, 2016

wben

Mechanical

thread561-314774
Hello, I'm new here in the forum, just tried to use a some of the macros. I'm using NX8.5 with the Routing Mechanical license but I cannot get the "Bend report" with the XYZ coordinates for bending tube. Under Tools-> is no option with Bend Report.
is the problem known or is maybe problem with NX configuration?
regards
Adam