Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Wrap sketch challenge

Status
Not open for further replies.
bustedenvelope

bustedenvelope

Mechanical
Jan 4, 2008
1
When wrapping a sketch on to a simple cylindrical surface SE randomly does not accept the geometry entered. And “sometimes” the wrapped sketch will be shifted parallel to the axis? Is this an input error or is this an SE issue?
 
Status
Not open for further replies.

Similar threads

josehdx
  • Locked
  • Question
projection of points from a sketch to a sketch
Replies
0
Views
231
josehdx
josehdx
lgscobie
  • Locked
  • Helpful tip
Helix wont work in 3d sketch 1
Replies
7
Views
240
bshand
bshand
WMaleux
  • Locked
  • Question
extract sketch out of section view
Replies
1
Views
220
beachcomber
beachcomber
WMaleux
  • Locked
  • Question
sketch in part won't turn black 1
Replies
2
Views
562
WMaleux
WMaleux
asadi2013
  • Locked
  • Question
Sketch Circular Pattern
Replies
7
Views
493
Kenny_G
Kenny_G

Part and Inventory Search

Sponsor

Back
Top Bottom