Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
WPS question
- Thread starter flight23
- Start date
Maybe. It depends on design conditions. Are impacts necessary? If so, then group number is an essential variable. As well, there are tighter thickness restrictions, etc. in impact tested applications. Review QW 25x for the applicable process.
Another potential issue could arise if your PQR tensiles broke in the base at < the minimum required TS for the filler metal.
You'd probably get a wider response if you posted this question in the welding forum.
Another potential issue could arise if your PQR tensiles broke in the base at < the minimum required TS for the filler metal.
You'd probably get a wider response if you posted this question in the welding forum.
- Status
Similar threads
- Locked
- Question