dsgnr1
Mechanical
- Feb 1, 2003
- 183
We were seeing a similar issue with configured bom as in thread559-184576. Intermittent bom numbering scheme problems with item numbers starting at 2 or 3 or 4. This is a very isolated problem it seems as there is little information on several fora.
The workaround:
In table properties, unselect all configs, then select all configs.
bom should re-number properly
dsgnr1 (regardless of signature...using 2007 sp5 now)
¿)
Version of SolidWorks: 2006
SolidWorks Sercive Pack:sp4.1
Operating System & Service Pack: win2k v5 (sp4)
Graphics Card and Driver version: Nvidia Quadro fx540, 7.1.8.4
Amount of installed RAM: 1GB
Virtual Memory settings: APPS, total paging = 1024mb
CPU Type & Speed: intel pent 4 / cpu 3.00GHz
The workaround:
In table properties, unselect all configs, then select all configs.
bom should re-number properly
dsgnr1 (regardless of signature...using 2007 sp5 now)
¿)
Version of SolidWorks: 2006
SolidWorks Sercive Pack:sp4.1
Operating System & Service Pack: win2k v5 (sp4)
Graphics Card and Driver version: Nvidia Quadro fx540, 7.1.8.4
Amount of installed RAM: 1GB
Virtual Memory settings: APPS, total paging = 1024mb
CPU Type & Speed: intel pent 4 / cpu 3.00GHz