Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Work Piece Won't Update, Keeps Saying (The input must be a number)

Thread starter Cid1979
Start date Apr 5, 2011

Status: Not open for further replies.

Apr 5, 2011

Cid1979

Automotive

I am you using NX 7.5 MR2, and everytime I go to update my work piece I keep getting the (Alerts) that says The inpute must be a number, now I know somebody out there is going to say so input a number did that LOL, tried a lot of things, but it keeps saying that. It will not change the numbers for some reason, anybody else run into this problem, help would be greatly appreciated.

I have attached a picture to show the alert.