Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
wood pullout resistance formula of sheet metal screw
- Thread starter delagina
- Start date
woodman88
Structural
- Oct 23, 2009
- 1,020
Neither. You would need to check out an ICC ES report or similar or call the manufacturer for values in this situation.
Garth Dreger PE - AZ Phoenix area
As EOR's we should take the responsibility to design our structures to support the components we allow in our design per that industry standards.
Garth Dreger PE - AZ Phoenix area
As EOR's we should take the responsibility to design our structures to support the components we allow in our design per that industry standards.
msquared48
Structural
If you are attaching a piece of sheet metal to a wood member, use a wood screw with a rounded head.
Mike McCann
MMC Engineering
Mike McCann
MMC Engineering
- Status
Similar threads
- Question
