Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Wiring Harness Drawing Standard 1

Status
Not open for further replies.
BridgetK

BridgetK

Mechanical
Joined
Aug 14, 2006
Messages
3
Location
US
I would like to know what the general rule is for Assembly Drawings for Wiring Harness. Would you use find numbers or reference designators? Or does it matter? This would be for military applications.

Thanks.
 
Sort by date Sort by votes
You might want to check to see if there is a MIL standard (assuming you are in the US) that would apply to drawing preparation and control. You might also find that they have incorporated some other standard for drawing preparation by reference.


Regards,
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

tlwhite0311
  • Question Question
Drawings for Every Machining Operation?
Replies
12
Views
7K
mfgenggear
mfgenggear
vayager4
  • Locked
  • Question Question
I have a drawing with OD thread ann
Replies
3
Views
300
btrueblood
btrueblood
NatJones
  • Locked
  • Question Question
Software suggestions for Standard Operating Procedures
Replies
9
Views
587
Jessica Walliams
Jessica Walliams
John Crist
  • Locked
  • Question Question
ASME Y14.24 Procurement drawings
Replies
0
Views
453
John Crist
John Crist
IvanPumps
  • Locked
  • Question Question
technical reference for coupling guard in australia standards
Replies
1
Views
254
PersonalProfile
PersonalProfile

Part and Inventory Search

Sponsor

Back
Top