Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Wired up

Status
Not open for further replies.

corus

Mechanical
Joined
Nov 6, 2002
Messages
3,165
Location
GB
Are there any guidelines for the bending of wire in terms of the minimum radius, projected length etc. for a given material and load? The wire in mind is expected to be about 5mm (3/16") in diameter and shaped like a C but with straight sides.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top