Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

why?

Status
Not open for further replies.
woody

woody

Electrical
Joined
Apr 15, 1999
Messages
3
Location
US
I made a mistake with my last post. It was a 371 Detroit diesel not a Cummins. I put 200 ohms of resistance on one of the field leads and that gets me down to a manageable voltage but it still doesnt tell me why I had the problem in the first place. Anyone with helpful hints please respond.
 
Sort by date Sort by votes
dear woody,<br>
<br>
rotor batary supply can burn if there are short cut or lose connection. the contact point at the board timely has lose connection and this cause hot and cable can burn.<br>
<br>
bye<br>

 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Mr zezo
  • Locked
  • Question Question
Why transformer insulation resistance decrease when filled with insulating oil?
Replies
2
Views
586
prc
prc
bdn2004
  • Question Question
Analyzing a 3-phase fault recorded waveform from an SEL relay on a 15kV feeder breaker, when did the breaker trip, why is VB at 0V before the fault ?
Replies
3
Views
10K
bdn2004
bdn2004
Dvhez
  • Locked
  • Question Question
Why isn't the immediate upstream breaker tripping in my 400V Arc Flash simulation?
Replies
2
Views
848
dpc
dpc
engr5678
  • Locked
  • Question Question
In cross bonding, why is there a voltage gradient between grounded and bonded points of sheath
Replies
4
Views
644
newelecteng
newelecteng
bdn2004
  • Locked
  • Question Question
Resistors in series with tripping coils in 125VDC power circuit breaker control schemes. WHY ?
Replies
5
Views
831
waross
waross

Part and Inventory Search

Sponsor

Back
Top