Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Which material has been assigned?
- Thread starter Trent5791
- Start date
You can add a material column to the assembly navigator. In the ANT, right click in the whitespace to the left of the component names, choose "columns" -> configure; on the columns tab, enter "Material" in the attribute entry and OK the dialog.
www.nxjournaling.com
www.nxjournaling.com
as Cowski notes but:
this applies if, you have set the customer default - Gateway - Materials / mass - attributes - Part material - Create Attribute = on
( this option might be on by default in 8.5 which i doubt it was in earlier versions.)
Regards,
Tomas
this applies if, you have set the customer default - Gateway - Materials / mass - attributes - Part material - Create Attribute = on
( this option might be on by default in 8.5 which i doubt it was in earlier versions.)
Regards,
Tomas
- Thread starter
- #4
- Thread starter
- #5
- Status
Similar threads
- Locked
- Question
