Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Which ISO standard defines if CZ can be called out with multiple modifiers in the same FCF

Status
Not open for further replies.

LukaPopovic

Student
Joined
Sep 13, 2024
Messages
1
Location
ME
Hi all,

I was looking through the ISO 1101 standard trying to find the right way a CZ symbol could be placed in the FCF, here are two cases which are causing confusion
First one:
2024-09-13_12-01-25_h1bfwy.jpg

Second case:
2024-09-13_12-02-42_whrnvq.jpg

Is there an ISO standard that specifies where the CZ should be places in similar cases?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top