Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Where can I find a Stainless Steel hydraulic jack?

Status
Not open for further replies.

DesignerMike

Mechanical
Jan 20, 2003
274
I'm looking for a hand or foot operated SS hydraulic jack, long stroke, light duty (less than 1000 pound cap). Something like you would see on an engine hoist or a pallet lift. Much like a McMastercarr 2923T51. I may be able to use a SS cylinder and a SS hand pump unit seperates.

Thanks for the help.
 
Replies continue below

Recommended for you

Hi Designermike,
The Miller SA series ( see ) 303/304 stainless caps, cylinder, rod, aluminum piston, will handle clean air or petroleum based fluid up to 400 psi. I think they will also supply this with stainless piston. There are probably other models and/or vendors, but this one sticks out in my memory. A few years back I was looking for hardware suitable for water hydraulics (not 90-10, just water) and discussed this with Miller. Sizes range from 1 1/8 to 8 inch bores.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor