Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

What could be the reasons?

Status
Not open for further replies.
SKSA

SKSA

Civil/Environmental
Joined
Feb 28, 2024
Messages
34
Location
CA
Hi there,

I run an analysis then extract the result in csv file and gave input as an initial condition in the next analysis. But I am facing some issues. The results should be like this photo:
132_vmm9qn.png


It is working fine for a model but when I use the different parts within same geometry then it shows some problem. And the results like this. I don't understand what could be the problem. This is the results that I am getting now.
12_mdxhwg.png


How to overcome this ?
 
Status
Not open for further replies.

Similar threads

killswitchengage
  • Locked
  • Question Question
What are the best free references for geotechnical forensic expertise ?
Replies
7
Views
628
killswitchengage
killswitchengage
Yusei
  • Locked
  • Question Question
What does a negative Poisson's ratio of soil and rock mean?
Replies
5
Views
1K
geotechguy1
geotechguy1
chaechaeng
  • Locked
  • Question Question
Determine the depth of GWT level
Replies
8
Views
1K
chaechaeng
chaechaeng
SKSA
  • Locked
  • Question Question
Varying the Mohr Cuolomb Parameters with time
Replies
3
Views
480
SKSA
SKSA
A.F
  • Locked
  • Question Question
1. What is the procedure of designi
Replies
5
Views
380
A.F
A.F

Part and Inventory Search

Sponsor

Back
Top