Weldment - Different peirce points at each end of the member 1

[chrisnewzealand]

I would like to know how to set up my diagonal member so that each end is located by a different pierce point. This would allow each end to only have one cut and the cuts would be parallel.

Attached is a picture of the solidmodel with what I have, also a drawing in paint of what I want.

I have solidowrks 2009.

Thanks in advance, Chris.

 

[Eltron]

Your weldment profiles can only be parallel with your sketch lines since they are just swept along the lines. You'll have to adjust your sketch.

Dan

http://www.eltronresearch.com

Dan's Blog

 

[CorBlimeyLimey]

Use sketch entities to describe the layout.

 

[chrisnewzealand]

Thanks CorBlimeyLimey, I should of thought of that!