Weldment Cut-List Question

[BodyBagger]

Hello All,
I have not used Sub Weldments before and I have a question. I have created a weldment that contains many items and I wanted to break down the assembly into 3 sub weldments each with their own drawings. I have already created the sub weldments by grouping the items and inserting into a new part and so on. The first one of the 3 has a fully filled in weldment cut list on the drawing but the other two keep bringing in empty cut lists. When I try to balloon the items they all come in as "0". Not sure why these last two are not working. Suggestions very welcome......
Thanks
BB

 

[Eltron]

Did you Update the Cutlist in the Part?

Dan

http://www.eltronresearch.com

Dan's Blog

 

[BodyBagger]

Hi Dan,
A couple of things. I have updated the cut list of the main weldment. Once the items are put into the "Sub-Weldment" there is no option to update there. Also, on the drawings where the cut list is not working, the balloons numbers all come in as "0". I hope this will help generate more suggestions.

Thanks in advance for any help.
BB

 

[BodyBagger]

I have resolved the issue. I believe that Dan was correct as to an "UPDATE" at the sub-weldment level. Thanks.
BB