Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Weld Repair ASME Section IX 1

Status
Not open for further replies.
nadfourchon

nadfourchon

Petroleum
Joined
May 20, 2008
Messages
26
Location
US
We have pipe welds (4130 to X80) that X-ray has found small isolated areas that need repair. This x-ray is BEFORE PWHT. Does ASME Sec IX QW-202.3 support me making these repairs without having an additional repair procedure as long as I following the procedure parameters originally used to make this weld? Or is there something else that states that I must have an additional PQR/WPS to support this type of repair?
 
Sort by date Sort by votes
Yes. Weld repairs can be performed using the same (original) WPS that was qualified to make the weld.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

timsch
  • Question Question
Question of scope of ASME BPVC SECTION IX
Replies
1
Views
9K
DekDee
DekDee
Karik87
  • Question Question
Combine thickness and diameter qualified range of welder according to ASME IX
Replies
4
Views
1K
Karik87
Karik87
V
  • Locked
  • Question Question
Is pressure retaining fillet weld qualification by fillet weld possible under ASME IX.
Replies
3
Views
3K
IdanPV
IdanPV
Motivated Apprentice
  • Locked
  • Question Question
Diameter in ASME IX
Replies
2
Views
1K
Motivated Apprentice
Motivated Apprentice
FAHADRANA
  • Locked
  • Question Question
WQT for Combination of Welders as per ASME Sec IX
Replies
3
Views
4K
DekDee
DekDee

Part and Inventory Search

Sponsor

Back
Top