Matsa
Automotive
- May 23, 2011
- 18
Hi,
Is there any way to do weld points with a sphere and a point(in NX8.5), that indicates how many parts that are connected? See atached picture..
It worked in NX5, but I can`t do it in NX8.5. Points that were created in NX5 also disappear when editing in NX8.5
I am using weld assistant in NX8.5.3.3.
Best regards / Matsa
Is there any way to do weld points with a sphere and a point(in NX8.5), that indicates how many parts that are connected? See atached picture..
It worked in NX5, but I can`t do it in NX8.5. Points that were created in NX5 also disappear when editing in NX8.5
I am using weld assistant in NX8.5.3.3.
Best regards / Matsa