Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

We are machining an aerospace aluminum connector shell out of 6061. Th

Thread starter jobeth
Start date May 22, 2000

Status: Not open for further replies.

May 22, 2000

jobeth

Mechanical

We are machining an aerospace aluminum connector shell out of 6061. The geometry is complex and requires CNC machining. I was wondering if there is any better material selection for aluminum CNC machining as well as recommendations of CNC shops to do this job. Any advice is welcomed. Thank you in advance.     William H. Bernhart, P.E. <a href=mailto: > </a> <a href= > </a>