Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Water-based chlorosulfonated polyethylene (CSM)

Status
Not open for further replies.
cm_lee

cm_lee

Chemical
Joined
Oct 18, 2019
Messages
2
Location
MY
Dear all,

Currently I am doing some research on dipped product using water-based chlorosulfonated polyethylene (CSM).
We are facing severe crack body and low tensile in my research.

I would like to ask is there any typical formulations for CSM to achieve tensile min 18MPa and can eliminate the crack body?


 
Status
Not open for further replies.

Similar threads

PaloAltoMark
  • Locked
  • Question Question
Hanging Silicone Water Container & Tensile Strength Calculation
Replies
0
Views
232
PaloAltoMark
PaloAltoMark
nightrain
  • Locked
  • Question Question
Problem in EPDM based rollers
Replies
4
Views
367
tom1953
tom1953
pqlong05
  • Locked
  • Question Question
sample preparation for Lab test: cooling down hot cured rubber in water is a proper way?
Replies
3
Views
281
stancom
stancom
Tetrahydrofuran
  • Locked
  • Question Question
ZDEC based vulcanizing package for latex sheeting
Replies
2
Views
221
Tetrahydrofuran
Tetrahydrofuran
thiadiazole
  • Locked
  • Question Question
about CPE (chlorinated polyethylene ) curing
Replies
4
Views
237
tom1953
tom1953

Part and Inventory Search

Sponsor

Back
Top