Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Warning: kl/r > 300

Status
Not open for further replies.
EngTomPE

EngTomPE

Structural
Joined
May 26, 2010
Messages
9
Location
US
I am getting the following incorrect message in SAP steel design output.

Warning: kl/r > 300 (AISC B7)

This is a tension member the actually has kl/r = 143

Has anyone else had this problem, and if so do you know if there is a fix for this bug.
 
Status
Not open for further replies.

Similar threads

X4vier
  • Locked
  • Question Question
KL/r<200 how to make SAP2000 omit this requirement on auto-select lists?
Replies
9
Views
2K
X4vier
X4vier
X4vier
  • Locked
  • Question Question
Make SAP2000 skip the KL/2<200 in an auto select list?
Replies
0
Views
216
X4vier
X4vier
STRUKT
  • Locked
  • Question Question
SAP2000 -> Design/Verification of Part of the Structure
Replies
8
Views
2K
SteelStructureDesign
SteelStructureDesign
N
  • Question Question
SAP 2000 - Center of Mass and Center of Rigidity
Replies
0
Views
5K
Neeka
N
s_saranya
  • Locked
  • Question Question
Pushover warning
Replies
0
Views
385
s_saranya
s_saranya

Part and Inventory Search

Sponsor

Back
Top