VIEW BREAK - NX8 1

[CAD2015]

Hi,
I'd like to create a view break that would finally show the yellow side of the part with an offset of, let's say, 10mm in each side.
How could I do this break view?
I tried but I can’t get totally the middle side of the part!

Thanks


MZ7DYJ

 

[CAD2015]

I know how to create a Single-Sided Break View.
What I'd like to know is how to apply the Regular one in this particular case......

MZ7DYJ

 

[JohnRBaker]

Just edit the view by adding a 'Single-Sided' View Break TWICE (two separate operations) one for each end of the view making sure that the reference direction points away from the view center, as I've done in the attached example.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[CAD2015]

Thanks a lot Mr. Baker!

MZ7DYJ