Rich944
Mechanical
- Feb 8, 2007
- 68
Hi all,
I am not sure if this is a problem with NX in general or just our system.
NX7.5
I have noticed when up revising drawings that the 'Break line/ Detail' view boundries have changed to 'Manual Rectangle' not only this but when I try to recreate the 'Break line / Detail' boundry I am unable to do this by draging the boundry lines.
Actually I have just figured this out but I will post this incase anyone else has the same issue:
Instead of dragging I just clicked once on the grey view line and I can now manipulate freely.
I'm pretty sure I always used to drag this, unless I am going crazy!
Rich
I am not sure if this is a problem with NX in general or just our system.
NX7.5
I have noticed when up revising drawings that the 'Break line/ Detail' view boundries have changed to 'Manual Rectangle' not only this but when I try to recreate the 'Break line / Detail' boundry I am unable to do this by draging the boundry lines.
Actually I have just figured this out but I will post this incase anyone else has the same issue:
Instead of dragging I just clicked once on the grey view line and I can now manipulate freely.
I'm pretty sure I always used to drag this, unless I am going crazy!
Rich
